It is
mainly used for tissue and cell culture, seed germination, seedling raising and
microbial culture. There are single beam or four beam, synthetic light kit. The
wavelength is mainly concentrated in red light and blue violet light, which is
mainly used for the culture of photosynthetic organisms.
Advantages
Flexible placement
●It can be used on the ground of single layer or on the ground of double layer
or three layers, and the experimental personnel can operate it easily.
● When the three sets are superimposed, the small stools are prepared for the
experimenters, and they are also equipped with iron rods for the installers to
manually lift the stools.
Drop-down, load-bearing box door
● After the box door is fully opened, an operation platform is automatically
formed, which can pull out 100% of the clamping plate of the oscillating bottle
to easily take and place the sample bottle. The shaking plate is directly
pulled or pushed without a locking device. The operation is simple and fast,
and the space utilization rate is greatly improved.
● The bottle splint is pulled out and pushed back along the special stainless
steel guide rail, which is firm and durable.
Intuitive touch panel
It has intuitive operation, precise control and monitoring, perfect appearance,
comfortable remote control function, and it is easy to clean.
Double glass door
● The toughened hollow double-layer safety glass door has good heat insulation
performance.
● Adopting double capillary refrigeration system and electronic expansion valve
control technology.
● Variable frequency compressor refrigeration system can be selected to save
energy and reduce emission, improve the service life of the compressor, lower
noise and more stable temperature control
Waterproof design of cultivation box
● Any accidental broken bottle during the cultivation process will not cause
damage to the incubator. You can also thoroughly clean the box with detergent
and sterilizer to ensure the best sterile environment in the box.
Viscous pallet
● The adhesive support pallet can directly fix culture flasks of various sizes
on the pallet without using clamps and is easy to clean. Easy to operate and
increase space utilization by 10%. The whole adhesive sheet is made of adhesive
material, special interlayer material, anti-ultraviolet, not easy to deform
after repeated use.
Single shaft balanced drive
● The single shaft balanced drive technology has no mechanical friction and
mechanical loss, no noise, no deviation, less energy consumption and good
coordination. It is suitable for long-term operation (see Figure).
Excellent control effect.
● With excellent control effect can achieve good stability and uniformity and
ensure that all culture bottles are in the same superior growth environment.
Ultra high carrying capacity to optimize the “benefit ratio per unit space” of
your valuable laboratory space to the greatest extent
● General support plate: 780×480 (mm), which can be mixed and placed with flask
clamp, test tube rack, enzyme label plate rack and universal spring shaking plate
of different sizes and specifications.
Full-function control design
● Adopt the original imported high-precision CO2 infrared sensor, shallow water
pan humidification, UV sterilization system and lighting system (standard), it
has adjustable ventilation holes on the side, optimized PID parameter, over
temperature protection and safety cut-off function. It also has fully optimized
oscillation system and balance system, parameter memory function, the audible
and visual alarm system. The alarm output interface can connect the alarm. It
can control the servo motor system. The bottom of the equipment is equipped
with rollers for easy movement. Customers can customize non-standard
temperature, oscillation speed, oscillation amplitude, humidification system and
illumination system. It also has expandable light culture control optional Kit,
expandable gas introduction unit and expandable shading culture unit.
Temperature control | Temperature range | 4 ℃ – 60 ℃ (Ambient temperature – 15 ℃, min. 4 ℃) |
Temperature uniformity | ± 0.5 ℃ (at 37 ℃) | |
Temperature accuracy | ±0.1℃ | |
Temperature recovery time | ≤±10mins | |
Ambient temperature range | 18-34℃ | |
Humidification mode | Natural humidification | |
CO2 concentration control | CO2 control range | 0.1-20% |
CO2 control accuracy | 0.1% | |
CO2 stability | ±0.1% | |
CO2 accuracy | ±0.3% | |
CO2 sensor | High temperature resistance of infrared (IR) sensor | |
Sterilization method | Ultraviolet sterilization | |
Concentration recovery time | ≤5mins open door 30S | |
Speed control | Rotation frequency | 30 ~ 300rpm (when three layers are stacked, the maximum speed of the top layer is 250rpm) |
Rotation accuracy | ±1rpm | |
Swing amplitude | 25 or 50mm optional | |
Humidity control (optional active humidification) | Humidity range | Ambient humidity – 95% |
Humidity control accuracy | 5% | |
Temperature regulation accuracy | 1% | |
Door opening recovery | 15min | |
Technical specifications | Capacity | 187L |
External dimensions | 1200*797*640 (excluding 80mm of footing) | |
Internal dimensions | 830*566*399H | |
Shaking plate dimensions | 780*480(mm) | |
Maximum capacity | 250ml 40 or 500ml 28 or 1000ml 15 or 2000ml 12 | |
Shaking plates number | 1 | |
Heating power | 800W | |
Refrigerating power | 200W | |
Net weight | 180Kg / single set | |
Maximum stacking | 3 | |
Product features | Display mode | 7-inch true color touch screen |
Control mode | P. I.D microcomputer environment scanning microprocessor chip control | |
Circulation mode | Forced convection | |
Oscillation mode | Rotary oscillating | |
Driving mode | Single shaft balancing device | |
Shaking plate | Free pulling type | |
Door opening mode | Lower two sets: pull-down type, top layer: turn up type | |
Printing function | Embedded built-in micro printer | |
Interface | USB data storage output | |
HEPA filter | The incoming gas is sterilized by 0.2um online filter | |
Lighting lamp | 8W | |
Ultraviolet lamp | 8W | |
Motor | High quality servo motor | |
Bearing | NSK original imported double row bearings | |
Shaft material | 45# carbon steel, 220-250HBW quenching and tempering treatment | |
Lumen material | 304 high-quality imported stainless steel plated plate | |
Main materials | High-quality and high-strength QT cast iron, channel steel, angle steel, high-quality cold-rolled steel plate | |
Bottle splint material | High quality aluminum plate, aluminum oxide surface treatment | |
Bottle clamp material | Made of stainless steel mirror material, the elasticity of the material is 360 degrees, the hardness is 420 degrees, and it is not easy to deform |
Get specific details about this product from customers who own it.
Fastest Delivery within Time
Delivering Uncompromising Quality
Product Online Payment
Your Trust, Our Responsibility